Connecting your Brother label printer is a quick and easy task, which takes less than 5 minutes.
What to take out of the box?
- Take the Brother Printer out of its physical box.
- Take out the power supply, power cable, and printer label roll. * There will also be an additional grey cable within your box. You will not need this.
- Remove the plastic sticker that is stuck to the display screen and Protective Sheet from the Label Output Slot.
- After removing the sticker and sheet, insert the label roll into the Roll holder. Make sure that the roll is inserted firmly into the Roll Spool located on the right inside of the device.
- Thread the label roll through the Label Output Slot, until the arrow appears.
The following image is all you will need to complete the setup.
- Connect the power supply and cable to the “DC IN 25V” Input located on the rear device and plug it into the nearest power outlet.
- Press the power button, and after 2 seconds a white screen will appear.
- Then you will be prompted to set the device language, time and clock.
What to click on the Printer Screen.
On the Printer, please set the following configuration:
- Go to Menu -> Template Settings ->Template Mode, and select OFF
- Go to Menu -> Bluetooth>>Bluetooth and select ON
- Go to Menu -> Bluetooth>>Automatic Reconnection and select ON
When the setup is correct, the printer's display should appear as follows: It's important to note that the Bluetooth icon, located in the top right corner of the screen, will be blinking because the Bluetooth connection has not been established yet.
If the Bluetooth icon is displayed. Your Printer is successfully connected to Bluetooth.
The initial printer setup has now been completed, next will be connecting to your iPad or compatible Android device.